Skip to content

Machining basics

Wire EDM vs Laser vs Plasma Cutting: Choosing the Right Process

Three ways to cut a profile in metal, compared by thickness, accuracy, edge quality and cost so you can ask for the right one.

2 min readBy the Alhamd Technologies team

All three processes cut a shape out of metal without a conventional cutting tool, but they are not interchangeable. Choosing the wrong one either wastes money or produces a part that needs hours of extra machining.

Plasma cutting: fast and economical on plate

A jet of ionised gas melts and blows the metal away. Plasma is the workhorse for profiling medium and thick steel plate. The edge has a slight bevel and a heat-affected skin, which is perfectly acceptable for fabrication and for blanks that will be machined afterwards.

Laser cutting: clean edges and fine detail

A focused beam gives a narrow cut, a square edge and small, accurate holes. Laser is at its best on sheet and moderate plate thicknesses and on parts that will be used as cut, such as covers, brackets and panels.

Wire EDM: precision in any hardness

A thin wire erodes the metal with electrical sparks while submerged in fluid. It is slow compared with the other two, but it is extremely accurate, leaves a fine finish and cuts fully hardened tool steel as easily as soft steel. It can also produce sharp internal corners.

Quick comparison

  • Rough blanks from thick plate, to be welded or machined: plasma
  • Sheet-metal parts with clean edges and many holes: laser
  • Dies, punches, splines and hardened parts: wire EDM
  • Very tight profile tolerances or tall, thin sections: wire EDM
  • Lowest cost per metre of cut: plasma, then laser, then wire EDM

Combining processes

Many jobs use more than one. A flange may be plasma-cut as a ring, turned on a lathe and drilled. A die block may be milled soft, hardened and then wire-cut to final profile. Tell the workshop what the finished part must do and let them plan the route.

Send us your drawing. We’ll make the part.

Share a drawing, a sample or a photo with dimensions. We will come back with price and delivery, usually the same day.

Or use the enquiry form